Specifications
Pile Points Menu
- Composite Pile Splices
- Concrete Pile Points
- Concrete Pile Splices
- H-Pile Points
- H-Pile Splice Attachments
- H-Pile Splices
- Pipe Pile Points
- Pipe Pile Splices
- Sheet Pile Points
- Timber Pile Points
- Timber Pile Splices
To purchase SPW911, visit our SPW 911purchase page.
To subscribe to Pile Buck Newspaper, visit our subscription page.
H-Pile Splice Attachments
- Scarf the outside edges of flanges of H to be added. Torch cut a 7/8 in. x 2 1/8 in. notch for spacer bar in either driven or added length.
- Slip splicer on pile (tap with sledge if needed). Make 5/16 x 2 1/2 in. fillet weld of splicer to flange at each corner.
- Set length to be added on driven H.
- Make 5/16 in. (or heavier) groove weld full width of each flange and at each remaining corner.